Ref Temp; Custom Setup - Emerson Rosemount 1056 Instruction Manual

Instruction Manual
LIQ-MAN-1056
6.5.7 Slope
The display screen for Entering the conductivity/temp
Slope is shown. The default value is displayed in bold
type. Refer to the toroidal conductivity Programming
flow diagram to complete this function.

6.5.8 Ref Temp

The display screen for manually Entering the Reference
temperature is shown. The default value is displayed in
bold type. Refer to the toroidal conductivity
Programming flow diagram to complete this function.
6.5.9 Filter
The display screen for entering the input filter value in
seconds is shown. The default value is displayed in
bold type. Refer to the toroidal conductivity
Programming flow diagram to complete this function.

6.5.10 Custom Setup

The display screens for creating custom curves for con-
verting conductivity to concentration is shown. Refer to
the toroidal conductivity Programming flow diagram to
complete this function.
When the custom curve data entry is complete, press
ENTER. The display will confirm the determination of a
custom curve fit to the entered data by displaying this
screen:
If the custom curve fit is not completed or is
unsuccessful, the display will read as follows and the
screen will return to the beginning custom curve screen.
52
Section 6.0: Programming the Measurements
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Slope
2.00%/ºC
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Ref Temp
(25.0ºC normal)
+25.0ºC
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Input filter
02 sec
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Custom Curve
Configure
Enter Data Points
Calculate Curve
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Calculate Curve
Custom curve
fit completed.
In Process Cal
recommended.
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Calculate Curve
Failure
April 2017