Settings On The Cd-Rom; Basic Program - Siemens SIMATRIX NEO V2 Configuration Manual

5.3

Settings on the CD-ROM

5.3.1

Basic program

Siemens AB
Security Products
a previously selected monitor and to switch video recorders and save images to
image memories.
The way detection groups are allocated to cameras, the way alarm images are
allocated to individual monitors and the choice between group or individual signal
transfer are all freely programmable.
The basic program and 6 alarm programs on the CD-ROM supplied with the device
provide a level of set-up that allows the system to be put to immediate use.
The programs supplied cover the most common applications. They also make it
easier to adjust programming to suit individual needs.
The SIMATRIX NEO V2 is set to use alarm program 2 at the factory. The other alarm programs are
described in the control software manual.
The SIMATRIX NEO V2 can be operated with or without alarm processing. The
same basic program is used in both cases.
Number of devices that can be connected
Cameras:
–
CDC:
–
Monitors:
–
Keyboards:
–
IVM-NT operating stations:
–
The basic program offers the following functionality:
Keyboard 1
–
Keyboards 2 to 4
Monitor cycles can be set for all monitors and can be password (PIN code)
–
protected
Camera designations, the date, the time and camera failure messages can all be
–
displayed on the monitor
The keyboard can be used to remotely control the most recently switched
–
camera via the SIMATRIX NEO V2 (if the camera is equipped with pan/tilt and
lens drives)
Presets per PTZ-drive (CDC) can be parameterized (Camera with special PTZ,
–
Lens with integrated potis and special CDC necessary)
1 to 48
1 to 48
1 to 4
1 to 4
1 to 3
controls monitors 1 to 4
control monitors 2 to 4
Total system with full options
17