Lincoln Electric POWER WAVE R450 Operator's Manual page 6

POWER WAVE R450
REGULATORY STATEMENTS
FCC
FCC ID: 2AJY8-LEWB0000111
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This device complies with part 15 of FCC rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Change or modifications that are not expressly approved by
the manufacturer could void the user's authority to operate
the equipment.
To comply with FCC RF exposure limits for general population
/ uncontrolled exposure, the antenna(s) used for this
transmitter must be installed to provide a separation distance
of at least 20cm from all persons and must not be operating in
conjunction with any other antenna or transmitter, except in
accordance with FCC multi-transmitter product procedures.
Industry Canada
IC: 22017-LEWB0000111
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
This equipment complies with RSS-102 radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum
distance 20 cm between the radiator and your body.
This radio transmitter (IC: 22017-LEWB0000111) has been
approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain
indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
Antenna Type: mono-pole 0.8 dBi
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage;
2) l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Cet équipement est conforme aux limites d'exposition de
rayonnement d'IC RSS-102 déterminées pour un
environnement non contrôlé.
Cet équipement devrait être installé et actionné avec la
distance minimum 20 cm entre le radiateur et votre corps.
Le présent émetteur radio (IC: 22017-LEWB0000111) a été
approuvé par Industrie Canada pour fonctionner avec les
types d'antenne énumérés ci dessous et ayant un gain
admissible maximal. Les types d'antenne non inclus dans
cette liste, et dont le gain est supérieur au gain maximal
indiqué, sont strictement interdits pour l'exploitation de
l'émetteur.
Le type d'antenne : mono-pole 0.8dBi
2
SAFETY