3 Getting Started
10
En
Introduction
This chapter covers switching on and setting the clock, using the Setup Navigator to set
some basic preferences, using all the basic controls for playing discs, and using the
tuner.
Switching on and setting the clock
This system has a built in clock, which needs to be set to be able to use the timer
features.
1
Press SYSTEM
to switch on.
2
Press SYS then TIMER/CLOCK ADJ.
Press the @ or # button until you see CLOCK ADJUST in the
3
display.
4
Press ENTER.
If you've just connected the power, the display shows 12:00 AM, with the hour
blinking.
Use the % and fi buttons to set the hour, then press ENTER.
5
Use the % and fi buttons to set the minute, then press ENTER.
6
The display blinks for 2 seconds to indicate that the time has been set.
Tip
Press
then
anytime to see the clock when the system is on or in standby.
SYS
DISP
Switching the time format
You can display the clock in either 12 or 24-hour format.
1
Switch the system into standby.
2
Press SYS then TIMER/CLOCK ADJ.
Press the @ or # button until you see CLOCK 12 HOUR or
3
CLOCK 24 HOUR in the display.
Use the % and fi buttons to select 12 or 24.
4
5
Press ENTER.