Using The Quick Setup - Pioneer VSX-D712 Operating Instructions Manual

5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position. If you want to make more specific
settings, refer to Choosing your receiver setup
on page 44.
Use the front panel controls for the steps
below.
ADVANCED STEREO/ SIGNAL MIDNIGHT/ SB CH
SURROUND DIRECT SELECT LOUDNESS SPEAKERS MODE TONE
PHONES SURR. MULTI JOG
LISTENING MODE
VIDEO INPUT
FL DIMMER
S-VIDEO VIDEO L AUDIO
1 If the receiver is off, press
STANDBY/ON to turn the power on.
The STANDBY indicator goes out.
2 Press QUICK SETUP.
SW DET flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
2.1ch
7.1ch*
6.1ch
* VSX-D812 only
MULTI JOG
ENTER
MASTER VOLUME
QUICK
SETUP
DOWN UP
R
3.1ch
4.1ch
5.1ch
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
2.0ch
7.0ch*
6.0ch
* VSX-D812 only
• Check the table below to find the speaker
setup that corresponds with your system.
* VSX-D812 only
4 Press ENTER.
5 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large ( S , M or L ), M being
an average-sized room.
6 Press ENTER.
3.0ch
4.0ch
5.0ch
02
13
En