Yellow Warning Lights - Dodge Charger SRT 2018 Owner's Manual

Hide thumbs Also See for Charger SRT 2018:
Table of Contents

Advertisement

— Seat Belt Reminder Warning Light
This light indicates when the driver or passenger seat belt is
unbuckled. When the ignition is first placed in the ON/RUN or
ACC/ON/RUN position and if the driver's seat belt is un-
buckled, a chime will sound and the light will turn on. When
driving, if the driver or front passenger seat belt remains
unbuckled, the Seat Belt Reminder Light will flash or remain
on continuously and a chime will sound. Refer to "Occupant
Restraints Systems" in "Safety" for further information.
— Transmission Temperature Warning Light — If
Equipped
This light indicates high transmission fluid temperature.
This may occur with strenuous usage such as trailer
towing. If this light turns on, stop the vehicle and run the
engine at idle or slightly faster, with the transmission in
PARK or NEUTRAL, until the light turns off. Once the light
turns off, you may continue to drive normally.
WARNING!
If you continue operating the vehicle when the Trans-
mission Temperature Warning Light is illuminated you
could cause the fluid to boil over, come in contact with
hot engine or exhaust components and cause a fire.
GETTING TO KNOW YOUR INSTRUMENT PANEL 121
CAUTION!
Continuous driving with the Transmission Tempera-
ture Warning Light illuminated will eventually cause
severe transmission damage or transmission failure.
— Trunk Open Warning Light
This indicator will illuminate when the trunk is open and
not fully closed.
— Vehicle Security Warning Light — If Equipped
This light will flash at a fast rate for approximately 15
seconds when the vehicle security alarm is arming, and
then will flash slowly until the vehicle is disarmed.

Yellow Warning Lights

— Engine Check/Malfunction Indicator Warning
Light (MIL)
The Engine Check/Malfunction Indicator Light (MIL) is a
part of an Onboard Diagnostic System called OBD II that
monitors engine and automatic transmission control sys-
tems. The light will illuminate when the ignition is in the
ON/RUN position before engine start. If the bulb does not
come on when turning the ignition switch from OFF to
ON/RUN, have the condition checked promptly.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

ChallengerSrt/hellcat2018

Table of Contents