Siemens M56 User Manual page 83

M56 Barracuda long, am english, A31008-H6350-A40-1-4A19 (28. July 2003,
• The access profiles must be set
manually.
If necessary, check with your service
provider for details.
Fax/data mod.
Fax/data mode using a PC
With the phone and a connected PC,
you can transmit and receive faxes
and data. Appropriate software for
fax and data communication must
be available on your PC and there
must be a connection to the phone.
Fax and data services must be
enabled by the service provider.
There are variations in fax and data
reception, depending on the net-
work. Please ask your service pro-
vider about this.
Set the required mode.
§Edit§
Rec fax/data
Your service provider has given
you a number for telephoning and a
fax/data number.
The call is signaled by a special ring
tone and the type of call (fax or data)
is displayed.
Now start the communication pro-
gram in your PC to receive the fax/
data.
Setup
Send vce/fax
Set this function on the phone before
transmission so that you can switch
from voice mode to fax mode.
While the connection is being set up,
the following function is available
for two seconds:
Switch to
§Voice/fx§
mode; you may now send
a fax.
Voice/fax rec
(Only if no special fax or data number
is available).
Start the required communication
program on your PC and select the
function on the phone during the
call (the PC will take over the
connection).
End transmission
End transmission with PC software
and/or press .
Authentication
Activate encrypted WAP
§Edit§
dial-up (CHAP: Challenge
Authentication Proce-
dure) or deactivate (PAP:
Personal Authentication
Procedure).
83
Send vce/fax