Touch Switches; Messages; Connect To Network - Technics SC-C70 Operating Instructions Manual

Touch switches

The touch switches do not work.
The touch switch operations are not done
properly.
• The touch switch operation may be disabled.
Check the setting. (⇒ 82)
• If this unit detects an abnormality of the touch
switches such as putting any objects on or
applying too much force on the touch switch, the
switches may not work temporarily.
Wait for at least 5 seconds, then press the
touch switch again.
If the touch switch cannot be activated, turn
this unit off and then on.

Messages

• The selected file cannot be played back.
• Select the playable file.
 For supported formats, refer to "File format"
(⇒ 107)
Adjust CLOCK
• Set the cock before setting the timer. (⇒ 76)
Adjust TIMER
• Set the starting time and finishing time of the
timer. (⇒ 78)
AUTO OFF
• The unit has been left unused for about
20 minutes and will shut down within a minute.
Press any button to cancel it.
Checking Device
• The unit is checking the connected USB device.
After this display has disappeared, start operating.
Connecting
• The unit is connecting to vTuner. Please wait for a
while. If the display does not change, switch the
input source, or turn the unit to standby and on
again.

Connect to Network

• Connect this unit to the network and then wait for
the start of the Firmware Update via Internet.
(⇒ 83)
Connect USB Device
• Download the latest firmware on the USB flash
memory and try again. (⇒ 84)
94
(Continued)