Advertisement
Ports
Ethernet
In AP and WB mode, the Ethernet port connects the device to a router or an existing wired network.
In WMC and WRE mode, the Ethernet port connects the device to the Ethernet-capable device that
would like to access the wireless network.
Power
The Power port connects the Access Point to the included power adapter.
Buttons
Reset
There are two ways to reset the Access Point to factory default settings. Either press and hold the Reset
button for approximately five seconds, or restore the defaults from the Administration > Factory
Defaults screen in the device's browser-based utility.
TM
Wi-Fi Protected Setup
If WAP300N is in AP mode and you have client devices, such as wireless adapters, that support Wi-Fi
Protected Setup, you can use this Wi-Fi Protected Setup button to connect your client devices to
WAP300N.
TM
If WAP300N is in WMC mode and you have wireless router that supports Wi-Fi Protected Setup
, you
can use this Wi-Fi Protected Setup button to connect WAP300N to your wireless router.
If WAP300N is in WRE mode and you have wireless router and wireless clients devices that support Wi-Fi
Protected Setup, you can use this Wi-Fi Protected Setup button first to connect WAP300N to your
wireless router and, once WAP300N is connected to your wireless router, you can then use the same
button to connect your wireless client devices to WAP300N.
NOTE: Wi-Fi Protected Setup is not supported when WAP300N is in WB mode.
Advertisement
