Pioneer VSX-D409 Operating Instructions Manual page 26

Preparations
Learning mode: Programming signals from other remote controls
(VSX-D509S only)
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this function to program in signals from the remote control(s) of your other component(s). This
operation can also be used after recalling a preset code to program additional operations not covered in the
preset codes.
SOURCE RECEIVER
DVD TV VCR
MULTI CONTROL
RCV CD TUN
1 2
MIDNIGHT 5.1CH ATT
4 5
2
SIGNAL SELECT EFFECT
7 8
+10 DISC
0
ENTER
TV CONTROL
TV
TV VOL TVFUNC MASTER VOLUME
MENU
CHANNEL
FQ
ST ST
ENTER
FQ
8
D.ACCESS BAND CLASS
3
1 ¡
MPX DTV ON / OFF DTV MENU
7
4 ¢
2
DSP TEST TONE
CH SELECT CH LEVEL FL DIMMER
LOUDNESS FUNCTION MUTING SETUP
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
memo The highlighted keys can
learn new functions.
SOURCE RECEIVER
DVD TV VCR
MULTI CONTROL
RCV CD TUN
1 2
MIDNIGHT 5.1CH ATT
4 5
SIGNAL SELECT EFFECT
7 8
+10 DISC
0
ENTER
TV CONTROL
TV
TVFUNC
TV VOL MASTER VOLUME
MENU
CHANNEL
FQ
ST ST
ENTER
FQ
8
D.ACCESS BAND CLASS
3 1 ¡
MPX DTV ON / OFF DTV MENU
7
4 ¢
2
DSP TEST TONE
CH SELECT CH LEVEL FL DIMMER
LOUDNESS FUNCTION MUTING SETUP
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
26
1 Press SETUP and hold for 3 seconds.
LED
The visible LED will blink twice.
2
CD-R
2 Press the MULTI CONTROL button for the
TVC
2
component you want to control and then
3
press 9, 7, then 5 to select the LEARNING
6
2
9
setup mode. The remote is ready to learn new
commands from other remote controls.
The LED flashes rapidly.
(
To cancel LEARNING setup mode
Press SETUP button.
After ten seconds if no commands are entered the remote will
revert to its previous mode.
3 Press the button to be programmed (for
example the 3 [play] button).
4 Point the remote controls at each other, about
1-2 inches apart, and press the button on the
other remote control for the operation you
1,5
want to program .
Î
1 Point the remote controls toward each other.
2 Press the button on the other remote control corresponding to the
operation you wish to program. The LED on this receiver's remote
will go out and then blink twice when the operation is learned.
Press the teaching key repeatedly, varying the distances between
the remotes, until you see this receiver's remote blink twice,
indicating the operation has been learned.
CD-R
TVC
To program additional operations for the current component
3
Repeat steps 3 and 4.
6
9
To program operations for another component
Repeat steps 2 through 4.
5 Press SETUP to exit the LEARNING setup
mode
After ten seconds of inactivity the remote control will automatically
leave the LEARNING mode and revert to its previous mode.
Î
memo
1 - 2 inches
Some commands from other remote controls cannot be learned,
but in most cases the remotes just need to be moved closer
together a farther apant.
)