Key Features - SanDisk SSD X100 Product Manual

SanDisk SSD X100

Key Features

1.2

Flash Memory used:

SanDisk 24nm 64Gb MLC ABL

Unformatted capacities

SATA 2.5": 64GB, 128GB, 256GB, 512GB

mSATA: 32GB, 64GB, 128GB, 256GB

Form factors:

SATA 2.5" 7.0mm case, complies with SFF-8223 and SFF-8201

SATA 2.5" 9.5mm case, complies with SFF-8223 and SFF-8201

Standard mSATA form factor with a Mini-PCIe edge connector, complies to
JEDEC MO-300B standard

Interface to host:

SATA 6Gb/s (Revision 3.0) compliant

Backwards compliant to SATA 3Gb/s & SATA 1.5Gb/s

ATA 8 Command Set ACS-2

NCQ support up to queue depth = 32

SMART support

High performance

Maximum Host transfer rate:

Sustained Sequential Read:

Sustained Sequential Write:

4K Random Write:

4K Random Read:

Write Latency:

Read Latency:

Low power consumption:

Typical read/write

Slumber power mode
2
The logical capacity of the drive conforms to the IDEMA HDD Specification. See
the listed capacity is used for formatting and other functions, and thus is not available for data storage. 1 megabyte
(MB) = 1 million bytes; 1 gigabyte (GB) = 1 billion bytes.
3
Performance for 256GB product on SATA 6Gb/s host, Queue Depth = 32. Based on internal testing; performance
may vary.
4
Average (typical) power while running MobileMark
Management (DIPM) enabled and Host Initiated Power Management (HIPM) enabled. 120mW for form factors with
input power of 3.3V ; 150mW for 2.5" standard SATA (5V).
5
With DIPM enabled. 70mW-75mW for form factors with input power of 3.3V ; 100mW for 2.5" standard SATA (5V).
© 2011 SanDisk® Corporation
Product Manual (Released)
2
:
3
:
4
:
5
:
TM
2007. X100 is configured with Device Initiated Power
9
6Gb/s
500 MB/s
430 MB/s
43,000 IOPS
76,000 IOPS
65µs
55µs
120mW to 150mW
70mW to 100mW
www.idema.org for details. Some of
Document No. 80-11-01842
Rev 1.0