Setting The Channel Levels - Pioneer S-DV700ST Operating Instructions Manual

Surround sound setup

Setting the channel levels

You can set the relative channel levels from
your main listening position for each listening
mode, including all the Surround and
Advanced Surround modes.
If you used the Room Setup feature (page 20),
the channel levels for each listening mode
will already be set. However, you can still fine-
tune the levels here if you need to.
STANDBY/ON
CD FM/AM
DVD TUNER
DISPLAY
DVD MENU
ENTER
MUTE
MASTER
VOLUME
TV CONTROL
CH
BASS MODE DIALOGUE
AUTO SURROUND SURROUND
PROGRAM REPEAT
AUDIO SUBTITLE
ZOOM TOP MENU
1
SYSTEM
SETUP TEST TONE TEST TONE
4
QUIET/
DIMMER MIDNIGHT
7
FOLDER–
CLR
MAIN SUB
1 Press SURROUND or ADVANCED
repeatedly to select a listening mode.
L1/L2
TV LINE
OPEN CLOSE
RETURN
SOUND
VOL
INPUT
VIRTUAL SB
ADVANCED
RANDOM
ANGLE
HOME
MENU
2 3
CH LEVEL
5 5 6
TIMER/
CLOCK
8 9
FOLDER+
0
ENTER
ROOM SETUP
2 Switch the remote control to SUB,
then press TEST TONE to hear the test
tone.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• RS – Right surround speaker
• LS – Left surround speaker
• SW – Subwoofer
3 Use the MASTER VOLUME +/– button
to adjust the volume to an appropriate
level.
4 Use the (cursor up/down)
buttons to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you're done, press ENTER to exit
test tone setup.
• The speaker volume can be adjusted
while listening to any sound source you
want by pressing CH LEVEL and then
using the (cursor up/down) buttons
to adjust the channel levels. After you're
finished with one channel, use the
(cursor left/right) buttons to move to the
next.
• Since the subwoofer produces ultra-low
frequencies its sound may seem quieter
than it actually is.
08
59
En