Connecting The Radio Antennas; Connecting External Antennas - Pioneer S-GX3V Operating Instructions Manual

Connecting up
• Make sure you connect both surround
speakers or you won't be able to hear
anything from the surround jacks.

Connecting the radio antennas

Connecting the supplied antennas will allow
you to listen to both AM and FM radio
broadcasts. If you find that reception quality is
poor, an outdoor antenna should give you
better sound quality—see Connecting external
antennas below for more on how to do this.
fig. a fig. b
3
AM LOOP
ANTENNA
ANTENNA
4
1 2
Note
1 The signal ground ( ) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety
ground.
fig. c
5
FM UNBAL
75Ω
1 Pull off the protective shields of both AM
antenna wires.
2 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3 Fix the AM loop antenna to the stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (fig. c) before clipping the loop to
the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface
and point in the direction giving the best
reception.
Don't let it come into contact with metal
objects and avoid placing near computers,
television sets or other electrical appliances.
5 Connect the FM wire antenna to the FM
UNLBAL 75 Ω Ω Ω Ω antenna terminal.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don't drape
loosely or leave coiled up.

Connecting external antennas

External AM antenna
Use 5–6 meters of vinyl-insulated wire and set
up either indoors or outdoors. Leave the AM
loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
wire)
AM LOOP
5–6m
ANTENNA
02
1
7
En