Advertisement
ADAS-500 Data Collection System
Getting Started
The software must be successfully installed before running the system. If you have not installed the software from
the distribution disks at this point, please refer to the previous section and do so now. If the software has been
successfully installed, you are ready to connect to the AMAC-500.
Connecting to the Crawler
The DCM requires an ethernet connection between the computer and the MCU-500. This connection utilizes a
standard Category 5 (Cat 5) ethernet cable with RJ-45 connectors. If you do not have the cable that shipped with
the system, you can use any standard Cat 5 cable. The system does not require a crossover cable, although, one can
be used.
The diagram below shows the connections required to use the system. The ethernet connection to the MCU-500
provides both position and UT data to the DCM. Be sure to select the UT device you are using by clicking on
Settings. You can select either the USN-52 or USN-58. Be sure to set the baud rate for the USN-52/58 to 9600.
MCU-500R
OFF
ON
ATCO
MCU-500R
Motor Control Unit
Figure 1 Connecting to the AMAC-500/MCU-500
Copyright © 2005-2009 ATCO. All Rights Reserved.
Rear Panel
PUS
H
REMOTE
STOP
CRAWLER
UT
DCM Host
Scope
Page 3
User's Manual
Section 3 Getting Started
Revision 1.0
Advertisement
