Using Hdmi Input; Using & Connecting Hdmi Equipment - Pioneer PDP-507XD Operating Instructions Manual

Enjoying through External Equipment

Using HDMI Input

This Plasma Television is equipped with two HDMI terminals
(INPUT 3 and 4) which accept digital video and audio signals.
To use the HDMI terminal, activate the terminal and specify the
types of video and audio signals to be received from the
connected equipment. For the types of these signals, see the
operation manual that came with the connected equipment.
Before starting the menu, press INPUT 3 or INPUT 4 on the
remote control unit or press INPUT on the Plasma Television to
select INPUT 3 or INPUT 4.
Input signal table
1920*1080i@50 Hz
720*576p@50 Hz
1280*720p@50 Hz
720(1440)*576i@50 Hz
1920*1080i@59.94 Hz/60 Hz
720*480p@59.94 Hz/60 Hz
1280*720p@59.94 Hz/60 Hz
720(1440)*480i@59.94 Hz/60 Hz
1920*1080p@24 Hz
For audio, the system supports the following:
• Linear PCM (STEREO 2ch)
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
NOTE
• PC signals are out of correspondence.
• It may take time until an image is displayed depending on the
equipment connected.
Connecting HDMI equipment
When using the INPUT 3 HDMI terminal:
Plasma Television (rear view)
SCART cable
(commercially available)
Connect the SCART cable
only when inputting
analogue audio signals.
HDMI equipment
3 4
HDMI cable having the
HDMI mark
(commercially available)
When using the INPUT 4 HDMI terminal:
Plasma Television (rear view)
3 4
HDMI cable having the HDMI mark
(commercially available)
HDMI equipment
To activate the HDMI terminal:
When you use the INPUT 3 HDMI terminal, use the following
procedure to activate the terminal.
1
Press HOME MENU.
2
then ENTER).
Select "Option" ( /
3
Select "HDMI Input" ( /
4
then ENTER).
Select "Setting" ( /
5
then ENTER).
Select "Enable" ( /
Item Description
Disable Deactivates the HDMI terminal.
(factory default)
Enable Activates the HDMI terminal.
6
Press HOME MENU to exit the menu.
NOTE
• You need not activate the INPUT 4 HDMI terminal; you
cannot manually deactivate this terminal.
To specify the type of digital video signals:
1
Repeat steps 1 to 3 provided for "To activate the HDMI
terminal."
2
then ENTER).
Select "Video" ( /
3
Select the type of digital video signals ( /
• If you select "Auto", an attempt will be made to identify
the type of digital video signals when digital video
signals are received.
Item Description
Auto Automatically identifies input digital video signals.
(factory default)
Colour-1
Digital Component Video signals (4:2:2) locked
Colour-2
Digital Component Video signals (4:4:4) locked
Colour-3 Digital RGB signals locked
4
Press HOME MENU to exit the menu.
then ENTER).
then ENTER).
12
59
En