Fluke 715 Instruction Sheet page 4

Shop for Fluke products online at:
1. With the Calibrator OFF, press the
displayed, where xx is the turn-off time in minutes. OFF
means the power saver is disabled.
]
2. Press and/or
off time in minutes.
3. To disable, press
TM
HART Resistor Mode
The calibrator has a user selectable 250 ohm HART
facilitate use with HART
can be switched in/out at any time by simultaneously pressing
V A
the and keys. Use a HART
measuring dc mA with loop power or sourcing mA.
Span Check Feature
The calibrator allows the users to store 0% and 100% setpoints
for each output function. Once setpoints are stored, the span
check feature allows the user to quickly toggle back and forth
from 0% to 100% or to step in 25% increments.
Automatic step and ramp modes can be enabled while in the
span check mode by simultaneously pressing the
First select the desired output mode (V,mV or mA) then preceed
to store the setpoints:
1. Storing 0% and 100% Setpoints
] }
2. Using the
output value for 0%.
] }
3. Press the
the 0% value.
4. Now using the
desired output value for 100%
5. Again, press the
store the 100% value.
www.
715 English Instruction Sheet
}
to increase or decrease the turn-
}
until the display shows OFF.
TM
communication devices. The resistor
TM
communicator when
controls set the output to the desired
scroll keys simultaneously to store
] }
controls set the output to the
] }
scroll keys simultaneously to
MyFlukeStore
Page 4
O
key. P.S.xx is
TM
resistor to
] }
keys.
1.888.610.7664
.com