Pioneer DVR-550HX-S Operating Instructions Manual page 133

The Initial Setup menu
Setting
HDMI Output
(only available when an HDMI device is connected)
Screen Resolution
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this
OPEN/CLOSE while holding down the
case, press
also switches Component Video Out on page 126 to the default setting).
• If you have the Colour set to YCbCr 4:2:2, you cannot select 720 x 576i (720 x 480i).
4:3 Video Output
Colour
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
• You cannot choose YCbCr 4:2:2 when the Screen Resolution is set to 720 x 576i (720 x 480i).
Audio Output
This setting is not available when a DVI device is connected
Options Explanation
1920 x 1080p Constant 1920 x 1080p output.
1920 x 1080i Constant 1920 x 1080i output.
1280 x 720p Constant 1280 x 720p output.
720 x 576p Constant 720 x 576p output (when setting the Input
(720 x 480p) Line System to 525 System, video is output in 720 x
480p).
720 x 576i Constant 720 x 576i output (when setting the Input
(720 x 480i) Line System to 525 System, video is output in 720 x
480i).
Full
Select if your HDMI TV allows you to change the
aspect ratio.
Normal Select if your HDMI TV does not allow you to change
the aspect ratio. 4:3 video will be shown with bars on
each side.
RGB (0–255)
Use if colours are weak and black appears to 'float'
on the RGB (16–235) setting.
RGB (16–235) Use this setting if colours appear overly rich and the
black too deep on the RGB (0–255) setting.
YCbCr 4:2:2
The video signal is output as a 10-bit YCbCr 4:2:2
component signal. This is the standard setting for
HDMI-compatible devices.
YCbCr 4:4:4 The video signal is output as a 8-bit YCbCr 4:4:4
component signal.
Auto •
Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the
Audio Out setting, number of audio channels, and
the HDMI-connected device, Linear PCM audio may
be output.
PCM All audio signals are converted to Linear PCM
(except DTS).
Bitstream Priority Select if the connected device is compatible with
bitstream audio.
(Stop) button on the front panel to switch the setting (this
.
16
133
En