Olympus Camedia D-360L Instructions Manual page 80

CARD SETUP ONE-FRAME ERASE SLIDE-SHOW MODE INDEX-DISPLAY MODE
You can run through all the stored pictures automatically. You can delete pictures you do not need.
This function works when the lens barrier is closed
ALL-FRAME ERASE
2
2
2 4
1
1
LCD monitor 1
1
LCD monitor
LCD monitor
LCD monitor
120
NEXT
123
NEXT
END
126
Caution:
• Never open the card cover, eject the card, remove the batteries, or
END
Note: pull the plug while erasing pictures. It may destroy the data in the
card.
• After the frame in the upper left corner is reached, the preceding group of
• When the picture is protected or the write-protect adhesive seal is Note: frames will be displayed. (When the + button is pressed, the succeeding
• The Slide-Show does not stop until you cancel the operation. Press the
placed on the card, the camera does not enter the Erase mode. Either group of frames will be displayed after the frame in the lower right
cancel the protection or remove the seal in order to erase pictures. Menu button to stop it. (When the AC adapter is not connected, the
corner.)
power turns off automatically after about 30 minutes.)
• It may take a few seconds before the picture is displayed. (Do not use the seal again.)
Downloaded From camera-usermanual.com Downloaded From camera-usermanual.com Downloaded From camera-usermanual.com Downloaded From camera-usermanual.com
74
4
3
2
4
3
3
3
SLOW
121 122
YES
FAST
NO
SET OK
124 125
SET OK
SET OK
127 128
YES
NO
SET OK
.
1 1
1 1
Close the lens barrier and Close the lens barrier and
Close the lens barrier, press Close the lens barrier and
press press press the the the
the LCD monitor ON/OFF
ON/OFF button to turn on the
ON/OFF button to turn on the ON/OFF button to turn on the
button and display the picture
LCD monitor.
LCD monitor. LCD monitor.
you want to erase.
2
Press the Menu button several
2 2
Press the Menu button several Press the Index-Display button
times to display the screen
2
on top to select the Index times to display the screen
Press the Erase button to
shown.
display. Up to nine frames are shown.
display the screen shown.
3
displayed
Select
3
currently selected picture. Select the speed using the +/– buttons and press the OK
3
button.
buttons.
Select YES using the +/–
3
• If the Menu button is pressed
Press the – button to select
buttons, then press the OK
4
while the setting is being
Press the OK button to start preceding frames.
button.
entered, it will be canceled and
the Slide-Show. • Press the + button to select
• One-Frame erase is also
the next setting menu will
• When SLOW is selected, it will succeeding frames.
available in the Index-Display
appear.
take approx. 15 sec. to move
mode. (p. 74)
4
4
Press to the next frame. When FAST the
Press the OK button again • See page 82 for All-Frame
button to cancel the Index- with YES selected to perform is selected, it will take approx.
erase.
All-Frame erase.
Display mode. The currently 2 sec. to move to the next
• It may take a while to perform
• When complete, NO PICTURE
selected picture is displayed frame.
One-Frame erase when Card-
appears on the LCD monitor.
• Slide-Show is also available in in one frame.
Print has been set for the card.
• Protected frames will remain in
the Index-Display mode. (p.
the card, and the last frame will
74)
be displayed. (p. 75)
• If the Menu button is pressed
• All-Frame erase is also
while the setting is being
available in the Index-Display
mode. (p. 74) entered, it will be canceled and
the next setting menu will
appear.
LCD LCD LCD monitor monitor monitor
including the
using the +/–
Index-Display