Table 2-1 Null Modem Adapter Pin Assignments - Cisco ONS 15454 Reference Manual
Ons sonet tl1
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Troubleshooting manual (558 pages)
Table of Contents
Advertisement
2.1.1 Open a TL1 session
Press Enter. An angle bracket prompt (>) appears.
Step 3
At the > prompt, type the Activate User command to open a TL1 session:
Step 4
ACT-USER:[<TID>]:<UID>:<CTAG>::<PID>;
Note
Type the Cancel User command to close a TL1 session:
Step 5
CANC-USER:[<TID>]:<USERID>:<CTAG>;
ONS 15600
The TSC card has one RJ-45 port of the faceplate. The RJ-45 port allows you to access the system using
a standard web browser. You must use the RJ-45 port on the active TSC. While using the web browser,
you can perform local and remote Operations, Administration, Maintenance and Provisioning (OAM&P)
functions.
If a browser is not available, you can access the system using one of the two RS-232 ports on the
Customer Access Panel (CAP). Each RS-232 port supports VT100 emulation so that you can enter TL1
commands directly without using a web browser. Each RS-232 port supports its own TL1 session.
Because the CAP RS-232 port is set up as a DTE interface, you must use a 3-pair swapping null modem
adapter so that the TXD/RXC, DSR/DTR, and CTS/RTS pins are swapped when connecting to the serial
ports. The null modem adapter connects the CAP RS-232 port (male configuration) and the serial cable
(female configuration).
Table 2-1
TSC Signal
NC
RXD
TXD
DTR
GND
DSR
RTS
CTS
NC
1. NC is Not Connected.
Attach a 3-pair swapping null modem adapter to the RS-232 port on the CAP.
Step 1
Connect a serial cable to the null modem adapter, and to the serial port on your PC or workstation.
Step 2
Complete one of the following:
Step 3
•
Cisco ONS SONET TL1 Command Guide, R6.0
2-4
When the semicolon is typed, the TL1 command is issued immediately.
Table 2-1
Null Modem Adapter Pin Assignments
From Pin at TSC (DTE) To Pin at Second DTE
1
1
2
3
4
5
6
7
8
9
If you are using a PC, configure the terminal emulation software (Hyperterminal):
Terminal emulation = vt100
–
lists the null modem adapter pin assignments.
NC
3
2
6
5
4
8
7
NC
Chapter 2
Procedures and Provisioning
Advertisement
Table of Contents
