Table of Contents
Advertisement
• Prog.Motion is disabled when Pure Cinema is set to
06
On.
• Black Setup has the effect only for pictures output
from the VIDEO output terminals and signals output
with a frame/field frequency of 60Hz.
• YNR, CNR, BNR and MNR have no effect on 1080/24p
video signals output from the HDMI OUT terminal.
Closing the Video Adjust screen
Press
HOME MENU.
About Pure Cinema
There are two types of video signals:
• Video material – Video signals recorded at 25 or 30
frames/second
• Film material – Video signals recorded at 24 frames/
second
"Pure Cinema" uses signal processing suited for "film
material" when converting 480i/576ior 1080i interlaced
video signals into progressive video signals, resulting in
clear picture reproduction without losing the quality of
the material.
is displayed on the disc information screen when
playing the "film material" pictures of BD-ROM, BD-R/-RE
and DVD-Video discs (page 31).
Adjusting the audio
Adjusting the Audio DRC
Audio DRC (Dynamic Range Control) has the effect of
playing loud sounds softly and soft sounds loudly. Adjust
the setting for example when viewing movies late at night
and the dialogs are difficult to hear.
1
During playback, display the TOOLS menu.
TOOLS.
Press
2
Select and set Audio Adjust.
Use / to select, then press ENTER.
3
Select and set Audio DRC.
Use / to select, then press ENTER.
4
Adjust the setting.
Use / to switch between Off, Low, Medium, High
and Auto.
Closing the Audio DRC screen
Press ENTER or
40
En
TOOLS
TOP MENU
ENTER
HOME
MENU
RETURN
HOME MENU.
Note
• This only affects the Dolby TrueHD, Dolby Digital Plus
and Dolby Digital audio signals of BDs and DVDs.
• When Auto is selected, the setting has the same
effect as High or Off for Dolby TrueHD signals,
depending on the content. For Dolby Digital Plus and
Dolby Digital, the setting has the same effect as Off.
• Audio DRC affects the audio signals output from the
following audio output terminals:
– Analog audio signals output from the AUDIO OUT
terminals.
– Linear PCM audio signals output from the DIGITAL
OUT terminal or HDMI OUT terminal.
• The effect may be weak for some discs.
Adjusting the output level of
the different speakers
during BD/DVD playback
(Channel Level)
Caution
• Channel Level of the speakers set to None or No at
Speaker Setup cannot be adjusted (page 47).
1
During playback, display the TOOLS menu.
Press
TOOLS.
2
Select and set Audio Adjust.
Use / to select, then press ENTER.
3
Select and set Channel Level.
Use / to select, then press ENTER.
4
Adjust the output level.
Use / to select, / to adjust.
The output levels of the L, C, R, SL, SR, SBL, SBR and SW
speakers can be adjusted within the range of –6.0 dB to
+6.0 dB.
L
C
R
SR
SBR
SBL
SL
SW
5
Press ENTER to set.
Note
• The adjustment of Channel Level is only applicable to
the sound output from AUDIO OUT.
• This cannot be adjusted when in the following cases:
– Output Terminal is set to HDMI or DIGITAL
AUDIO (page 51).
– Audio Output Mode is set to 2 Channel
(page 43).
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
Advertisement
Table of Contents
