Receiving Instructions; Pre-Installation Instructions - Trane GGAA Installation, Operation And Maintenance Manual

Receiving Instructions

Inspect shipment immediately when received to determine if any damage has occurred to the
crate during shipment. After the unit has been uncrated, check for any visible damage to the unit.
Check motor position and turn blower wheel to determine if damage has occurred to these
critical parts. If any damage is found, the cosignee should sign the bill of lading indicating such
damage and immediately file claim for damage with transportation company.

Pre-Installation Instructions

This equipment has been test fired and inspected. It has been shipped free from defects from our
factory. However, during shipment and installation, problems such as loose wires, leaks or loose
fasteners may occur. It is the installer's responsibility to inspect and correct any problems that
may be found.
When the unit is received and uncrated, check the external data plate and all labels on the unit for
type of gas, electrical, and operational specifications to confirm that these agree with those at
point of installation. The unit is equipped with an Indoor Duct Furnace. Check the data plate and
all labels located inside each furnace.
Every unit will include an informational packet which will include the following:
•
•
•
•
•
N N o o t t e e : : It is the owner's responsibility to provide any scaffolding or other apparatus required to
6
Blower manual
Indoor duct furnace and evaporative cooler/cooling coil manuals (if applicable)
Wiring diagram(s)
Factory installed service convenience options manual (if applicable)
Special controls/data sheets
perform emergency service or annual/periodic maintenance to this equipment.
MUA-SVX005B-EN