Panasonic KX-FP81BX Service Manual page 87

2.4.4. SERVICE FUNCTION TABLE
Code Function
501 Pause time set
502 Flash time
503 Dial speed select
511 VOX sense
520 CED frequency select
521 International mode select
522 Auto standby select
523 Receive equalizer select
550 Memory clear: To reset the value to the default one, except the top margin
(853) and left margin (854).
551 ROM check
552 DTMF single tone test
553 Monitor on FAX communication
select
554 Modem test
555 Scan check
556 Motor test
557 LED test
558 LCD test
559 Document jam detection select
570 BREAK % select
571 ITS auto redial time set
572 ITS auto redial line disconnection
time set
573 Remote turn-on ring number set
590 FAX auto redial time set
591 FAX auto redial time disconnection
time set
592 CNG transmit select
593 Time between CED and 300bps
594 Overseas DIS detection select
Set Value Effective Default
Range
X 100 msec 001~600
X 10 ms 01~99
1:10 pps 2:20 1, 2
pps
1:High 2:Low 1, 2
1:2100 Hz 1, 2
2:1100 Hz
1:ON 2:OFF 1, 2
1:ON 2:OFF 1, 2
1:ON 2:OFF 1, 2
1:ON 2:OFF 1, 2
1:OFF 1~3
2:PHASE B
3:ALL
1:ON 2:OFF 1, 2
1:61% 2:67% 1, 2
X number of 00~99
times
X second 005~999
X number of 01~99
rings
X number of 00~99
times
X second 005~999
1:OFF 1~3
2:ALL
3:AUTO
1:75 msec 1~3
2:500 msec
3:1 sec
1:detects at 1, 2
the 1st time
2:detects at
the 2st time
87
Remarks
50 ----------
70 ----------
1 ----------
1 When the TAM (or EXT TAM) does not stop
recording the ICM because noise is detected on
the telephone line, change this setting to "LOW".
1 See Symptom/Countermeasure Table for long
distance and international calls in 2.3.5.1.5. THE
UNIT CAN COPY, BUT CANNOT EITHER
TRANSMIT/RECEIVE LONG DISTANCE OR
INTERNATIONL COMMUNICATIONS (P.50).
1 See Symptom/Countermeasure Table for long
distance and international calls in 2.3.5.1.5. THE
UNIT CAN COPY, BUT CANNOT EITHER
TRANSMIT/RECEIVE LONG DISTANCE OR
INTERNATIONL COMMUNICATIONS (P.50).
1 The resolution reverts to the default when
transmission is complete.
2 When the telephone station is far from the unit or
reception cannot be performed correctly, adjust
accordingly.
"START" input
See 2.5. TEST FUNCTIONS(P.99).
2 See 2.5. TEST FUNCTIONS(P.99).
1 Sets whether to monitor the line signal with the
unit´s speaker during FAX communication or not.
See 2.5. TEST FUNCTIONS(P.99).
See 2.5. TEST FUNCTIONS(P.99).
0 See 2.5. TEST FUNCTIONS(P.99).
See 2.5. TEST FUNCTIONS(P.99).
See 2.5. TEST FUNCTIONS(P.99).
1 See 2.2.1. DOCUMENT JAMS(P.27).
1 Sets the % break of pulse dialing according PBX.
05 Selects the number of times that ITS is redialed
(not including the first dial).
65 Sets the interval of ITS redialing.
15 Sets the number of rings before the unit starts to
receive a document in the TEL mode.
5 Selects the number of redial times during FAX
communication (not including the first dial).
65 Sets the FAX redial interval during FAX
communication.
2 Lets you select the CNG output during FAX
transmission. ALL: CNG is output at phase A.
AUTO: CNG id output only when automatic dialing
is performed. OFF: CNG id not output at phase A.
Refer to 2.3.5.1.2. SOMETIME THERE IS A
TRANSMIT PROBLEM(P.48).
1 See Symptom/Countermeasure Table for long
distance and international calls in 2.3.5.1.5. THE
UNIT CAN COPY, BUT CANNOT EITHER
TRANSMIT/RECEIVE LONG DISTANCE OR
INTERNATIONL COMMUNICATIONS (P.50).
Refer to 2.3.5.1.3. RECEIVE PROBLEM(P.49)
and 2.3.5.1.5. THE UNIT CAN COPY, BUT
CANNOT EITHER TRANSMIT/RECEIVE LONG
DISTANCE OR INTERNATIONL
COMMUNICATIONS (P.50).
1 See Symptom/Countermeasure Table for long
distance and international calls in 2.3.5.1.5. THE
UNIT CAN COPY, BUT CANNOT EITHER
TRANSMIT/RECEIVE LONG DISTANCE OR
INTERNATIONL COMMUNICATIONS (P.50).
Refer to 2.3.5.1.2. SOMETIME THERE IS A
TRANSMIT PROBLEM(P.48) and 2.3.5.1.5. THE
UNIT CAN COPY, BUT CANNOT EITHER
TRANSMIT/RECEIVE LONG DISTANCE OR
INTERNATIONL COMMUNICATIONS (P.50).
KX-FP81BX / KX-FP81CX / KX-FP82CX