Dvd/Cd/Video Cd Player - Pioneer S-EV1000V Operating Instructions Manual

Additional information
Problem
The microphone can't be heard. • Stop the disc, then restart playback.
Feedback noise when mic is
switched on.
SND. DEMO shows in the
display and the unit can't be
controlled.
TRAYLOCK shows in the display
and the tray can't be ejected.

DVD/CD/Video CD player

Problem
The disc is ejected automatically
after loading.
Playback is not possible.
Picture playback stops and the
operation buttons cannot be
used.
Settings are canceled.
No picture/No color.
Screen is stretched or aspect
does not change.
When recorded on a VCR or
passed through an AV selector,
there is disturbance in the
playback picture.
Remedy
• You are only using one microphone and it's plugged into the MIC
(SUB) jack. The MIC (SUB) jack can only be used if there is also a
microphone plugged into the MIC (MAIN) jack.
• Adjust the MIC VOL.
• The mic is pointing toward the speakers. Keep the mic pointed
away from the speakers.
• The microphone level is set too high. Turn down the mic control
level.
• Press and hold (stop) on the front panel for about five seconds.
The disc tray ejects automatically to indicate the Sound Demo
mode is disabled.
• Press and hold (eject) on the front panel for about eight
seconds. Then the tray can be opened/closed using
Remedy
• Clean the disc.
• Align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the
number on the player, the disc cannot be used (see DVD Video
regions on page 49).
• Allow time for any condensation inside the player to evaporate.
Avoid using the player near an air-conditioning unit.
• Disc may be loaded upside down. Reload the disc with the label
side face up.
• Press , then start playback again ( ).
• Switch the power off once, then on again using the front panel
STANDBY/ON button.
• When the power is cut due to power failure or by unplugging the
power cord for several days, settings will be canceled.
• Check that connections are correct and that plugs are inserted
fully.
• Check the instruction manual of the TV/monitor to make sure the
TV/monitor settings are incorrect.
• The TV Screen setting is incorrect. Set the TV Screen option to
match the TV/monitor you're using (see Video Output settings on
page 44).
• Due to the player's copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
15
(eject).
55
En