Getting started
Chapter 4
Getting started
Setting the clock
Setting the clock allows you to use the timer.
SYSTEM SETUP
TOP MENU
TUNE +
DVD MENU
HOME
MENU
ST –
ST +
ENTER
SOUND
RETURN
MODE
TUNE –
1
Press TIMER (SHIFT+6).
2
If 'CLK ADJ?' isn't in the display, select it
with
or
, then press ENTER .
3
Use
/
to set the hour. Press ENTER .
4
Use
/
to set the minute then press
ENTER to confirm.
Setting up the remote to control
your TV
You can set up the supplied remote to control
your TV using the TV CONTROL buttons.
1
Switch on your TV.
2
Find the name of the manufacturer of
your TV in the Preset Code List on page 60.
Next to each manufacturer is one or more
three digit codes. These tell the remote what
kind of TV you have.
If the name of the manufacturer of your TV
does not appear in the table, you won't be able
to set up this remote to control your TV.
Note
1 The default setting is 12-hour format. See Optional system settings on page 48 to change it.
2 • The default setting is for a Pioneer TV.
• Note that there are also cases where the codes listed for a manufacturer in the Preset Code List may not work for your TV.
3 The screen saver will appear after five minutes of inactivity.
1
3
ST.MEMORY
MONO
TIMER
4
5
6
ENTER
TEST TONE
CH LEVEL
7
8
9
0
TV CONTROL
INPUT
CHANNEL
VOLUME
SHIFT
2
3
Point the remote at your TV, hold down
the CLEAR button, then enter the three
digit code for your TV.
The remote transmits an on/off signal to the TV.
If you've entered the correct code, your TV
should switch off.
If your TV doesn't turn off, repeat the procedure
using the next code in the list until your TV
switches off successfully. Once set, you can
then use the individual TV controls shown
below.
Button
What it does
Switches your TV on or into
standby.
CHANNEL +/–
Changes the TV channel.
VOLUME
Adjusts the volume.
INPUT
Switches the TV's input
between the built in TV tuner
and an external video source.
Using the on-screen displays
For ease of use, this system makes extensive
use of graphical on-screen displays (OSDs).
All the screens are navigated in basically the
same way, using the cursor buttons ( ,
) to change the highlighted item and
pressing ENTER to select it.
04
,
,
3
19
En