Playback; Single Playback; Blank Skip - Pioneer CT-W208R Operating Instructions Manual

PLAYBACK

SINGLE PLAYBACK (Either DECK I
or DECK II)
2
Ωı¿ˆ<?˘B
Î
STEREO DOUBLE CASSETTE DECK
DECK I
+
MS
–
COPY I 3 II
NORMAL HIGH
DOLBY NR
B
AUTO REVERSE
Auto Tape Selector
MUSIC SEARCH SYSTEM / PLAYBACK
POWER
DECK @ I
— OFF _ ON
1 5
1. Load a prerecorded tape in DECK I or II.
2. Set the DOLBY NR switch.
÷
Always set the switch to the same position
that was used for recording.
3. Set the REV MODE switch (see page 9).
4. Set the stereo amplifier for tape playback.
Press the playback (3 or 2) button of either
5.
DECK I or II.
To stop playback temporarily(DECK II only)
Press the pause (8) button.
÷ To resume playback, either press the pause (8)
button again, or press the playback (3 or 2) button.
To stop playback
Press the stop (7) button.
NOTE:
When the play button (forward) is pressed during fast
forward, the unit will play back in the reverse direction,
and then play back in the forward direction. (vice versa
for reverse)
Example: When 3 is pressed during fast forward:
Reverse play
Fast
= =
stop
forward (0.5 seconds)
3
DECK @ II
+
MS
–
DECK II
REV MODE
OFF C
RELAY/SKIP
AUTO REVERSE
Auto Tape Selector
MUSIC SEARCH SYSTEM / PLAYBACK
REC
LEVEL
HIGH SPEED
COPY SYSYEM
DECK @ II
MIN MAX
DOLBY B-C NR
(5) (1)
Forward
= =
stop

BLANK SKIP

This function allows you to skip unrecorded portions
of the tape during playback.
Set the REV MODE switch to
NOTES:
÷ When the REV MODE switch is set to the
position, the relay mode will be selected.
÷ When this mode is selected, if the tape deck encoun-
ters an unrecorded portion of tape more than 15 sec-
onds in length, it will fast forward the tape until it
encounters another recorded portion, and resume
playback from that point.
play
REV MODE
O p π
RELAY/SKIP
.
11