Installation
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 11)
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 12) (Fig. 13)
Factory radio mounting bracket
77
Frame
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fitted),
and tighten the screws at 2 places on each side. Use either
× 6 mm) or flush surface screws
binding screws (5
(5 × 6 mm), depending on the shape of the screw holes in
.
the bracket
12
Insert the release pin into the hole in
the bottom of the frame and pull out
to remove the frame.
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
11
Screw
13
Dashboard or Console
Fig. 11
Fig. 12
Fig. 13