Understanding Auto Eq Error Messages; Indicator List - Pioneer MVH-P8200 Operation Manual

Appendix
Additional Information
Bluetooth Telephone
Message Cause
Error-10
The power failed
for the Bluetooth
module of this
unit.
Understanding auto EQ
error messages
When correct measurement of the car's inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
Message Cause
Error. Please The microphone
check MIC. is not connected.
Error. Please The microphone
check xxxx
cannot pick up
speaker.
the measuring
tone of a speaker.
Error. Please
The surrounding
check noise. noise level is too
high.
48
En
Action
Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Action
Plug the optional
microphone se-
curely into the
jack.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Set the micro-
phone correctly.
Message Cause
Error. Please Power is not
check battery. being supplied
from the battery
to this unit.

Indicator list

Common
(MVH-P8200BT only)
Indicates that a Bluetooth tele-
phone is connected.
(MVH-P8200BT only)
Indicates the signal strength of the
cellular phone.
Shows when tag information is
stored in this unit.
Flashes when the tag is being
transferred to an iPod.
Indicates that Auto EQ is on.
iPod
1
Shows when repeat play is set to
One or All.
Shows when shuffle function is on.
Shows when the sound retriever
S.Rtrv
function is on.
Action
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Connect the bat-
tery correctly.