Basic Operation Of Cd - Pioneer DVH-P7000 Owner's Manual

Section
Playing CDs on the
06
built-in player

Basic operation of CD

1 Press on the head unit to open the
OPEN
front panel.
Disc loading slot appears.
• After inserting a CD, press
the built-in player.
• Pressing
SOURCE
forms the same operation.
2 Insert a CD into the Disc loading slot.
When you set
AUTO PLAY :ON
automatically start. If you set
press to select
SOURCE
Disc loading slot
button
EJECT
• You can eject a CD by pressing
head unit.
• To avoid a malfunction, make sure that no
metal object comes into contact with the front
panel is open.
3 After a CD has been inserted, close the
front panel.
4 Use
VOLUME
Press to increase or decrease the vol-
VOLUME
ume level.
• Rotating
VOLUME
increases or decreases the volume.
5 To skip back or forward to another track,
press 4 or ¢ .
Track numbers are displayed for 8 seconds.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
42 En
to select
SOURCE
on the head unit also per-
, playback will
AUTO PLAY :OFF
(refer to page 19).
DVD
EJECT
to adjust the sound level.
on the head unit also
• If the remote control is set to
4 and ¢ do not operate. In this case,
press 1 or ¡ to skip to another track.
6 To perform fast forward or reverse, press
and hold 1 or ¡.
• Pressing and holding 2 or 3 on the head unit
also performs the same operation.
• If you continue pressing 1 or ¡ for 5
seconds, the color of the fast reverse/fast
forward mark (
white to blue. When this happens, fast
reverse/fast forward continues even if you
,
release 1 or ¡. To resume playback at a
desired point, press 6.
• If you fast forward to the end of a CD, fast
forward continues from the beginning of
the disc.
• If you fast reverse to the beginning of a CD,
normal playback resumes.
Notes
• The built-in player plays one, standard,
12-cm or 8-cm (single) CD at a time. Do not
on the
use an adapter when playing 8-cm CDs.
• Do not insert anything other than a
DVD/Video CD/CD into the Disc loading slot.
• If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press
EJECT
disc for damage before inserting the disc
again.
• If the built-in player does not operate properly,
an error message such as
displayed. Refer to Error messages on page 89.
DVH
/ ) changes from
to eject the disc, and check the
ERROR-11
mode,
may be