5
UTILITY PACKAGE (GX Configurator-AD)
5.8
Usage of FB
This section describes the procedure for using FB with GX Developer.
For details, refer to "GX Developer Version 8 Operating Manual (Function Block). "
5.8.1
The procedure for creating FB is shown below.
(1) Set up the intelligent function module parameter (initial setting/auto refresh
(2) Convert the intelligent function module parameter into FB.
(3) Paste the FB to a sequence program.
(4) Convert (compile) the sequence program.
Next, a flowchart of procedures 1) to 4) is shown below.
GX Configurator-AD
GX Developer
5.8 Usage of FB
5
- 30
5.8.1 Outline
Outline
setting).
1)
Set up the initial setting/auto refresh setting.
2)
Convert the parameter into FB.
3)
Paste the FB to a sequence program.
4)
Convert (compile) the sequence program.
Start
End
Refer to sections 5.4 and 5.5.
Refer to sections 5.7.
Refer to sections 5.8.2.
Refer to sections 5.8.3.