Additional Information; Troubleshooting; Additional Information Troubleshooting - Pioneer AVH P4300DVD Owner's Manual

Appendix

Additional Information

Troubleshooting

Common
Symptom Cause
The power will Leads and con-
not turn on. nectors are incor-
The unit will rectly connected.
not operate.
The fuse is
blown.
Noise and/or
other factors are
causing the built-
in microproces-
sor to operate in-
correctly.
Battery power is
Operation with
the remote low.
control is not
Some operations
possible.
are prohibited
The unit does
with certain
not operate
discs.
correctly even
when the ap-
propriate re-
mote control
buttons are
pressed.
Playback is not The disc is dirty.
possible.
The type of disc
loaded cannot be
played on this
unit.
The disc loaded
is not compatible
with this video
system.
There is no Cables are not
sound. connected cor-
The volume rectly.
level will not
The unit is per-
rise.
forming still,
slow motion or
frame-by-frame
playback.
86
En
There is no
Action (Refer-
image dis-
ence page)
played.
Confirm once more
that all connec-
tions are correct.
Rectify the cause
and then replace
the fuse. Be sure to
The
install a fuse with
displayed, and
the same rating.
operation is not
possible.
Press RESET. (Page
11)
The image dis-
Load a new battery.
played stops
(pauses) and
the unit cannot
Try operating with
be operated.
another disc.
There is no
sound.
The volume
level is low.
The sound and
video skip.
Clean the disc.
Check the disc
type.
The aspect
ratio is incor-
Change the disc to
rect and the
one that is compa-
image is
tible with your
stretched.
video system.
The motor
Connect the cables
sounds when
correctly.
the ignition
switch is
There is no sound
turned ON (or
during still, slow
is turned to
motion or frame-
ACC).
by-frame playback.
Symptom Cause
The parking
brake cable is
not connected.
The parking
brake is not ap-
plied.
icon is The operation is
prohibited for the
disc.
The operation is
not compatible
with the config-
uration of the
disc.
The data could
no longer be
read during play-
back.
The volume level
is low.
The attenuator is
on.
The unit is not
firmly secured.
File size and
transmission rate
are above recom-
mended rates.
The aspect ratio
setting is incor-
rect for the dis-
play.
The unit is con-
firming whether
or not a disc is
loaded.
Action (Refer-
ence page)
Connect the park-
ing brake cable,
and apply the park-
ing brake.
Connect the park-
ing brake cable,
and apply the park-
ing brake.
This operation is
not possible.
This operation is
not possible.
Stop playback
once, and start
playback again.
Adjust the volume
level.
Turn the attenuator
off.
Firmly secure the
unit.
Create a DivX file
that is within the
recommended size
and transmission
rate.
Select the appro-
priate setting for
your display. (Page
61)
This is a normal
operation.