Table of Contents
Advertisement
8
Energy saving information
8
Energy saving information
Heating economically
The appliance has been designed, so that the gas
consumption and environmental impact are as low as
possible yet comfort is at its optimum level.
Inspection/Maintenance
So that gas consumption and environmental impact can
be kept as low as possible for as long as possible, we
recommend that you take out an inspection and
maintenance contract with an approved contractor
covering an annual inspection and service subject to
demand.
Heating controls
Install the heating control unit with room temperature
controller or a weather-compensated controller and
thermostatic valves.
For further information, see the relevant installation and
operating instructions of the controller.
Heating systems with weather-compensated
control unit
With this type of control, the outside temperature is
captured, and the heating flow temperature is adjusted in
accordance with the heating curve set at the controller.
The lower the outside temperature, the higher the flow
temperature.
Set the heating curve as low as possible. Turn the
appliance temperature controller to the maximum design
temperature of the heating system.
Heating systems with room temperature-
dependent control
The room where the room temperature controller is
installed (reference room) determines the temperature in
other rooms. Thermostatic valves should not be installed
in the reference room.
Set the appliance temperature controller to the maximum
design temperature of the heating system.
In each room (except the reference room), the
temperature can be regulated individually by means of
thermostatic valves. If a lower temperature is required in
the lead room than in the other rooms, reference the room
temperature controller set as is and reduce the
temperature at the radiator valve.
Thermostatic valves
Fully open the thermostatic radiator valves in order to
achieve the required room temperature. Change the
required room temperature at the temperature controller
only if the temperature is not achieved after a prolonged
period.
12
Venting
Never leave windows slightly open for ventilation
purposes. Otherwise, heat will be constantly discharged
from the room without significantly improving the air
quality in the room. It is better to fully open windows
briefly.
Close thermostatic radiator valves whilst airing rooms.
Now you know how to heat economically with the heating
system. Contact your installer should you have further
questions – alternatively, write to us.
Logano plus SB745 - Subject to technical modifications
Advertisement
Table of Contents
