Dismantling - Husqvarna 122 HD60 Workshop Manual

Electrical system

Dismantling

First dismantle the following:
The starter cover, the spark plug and the
protective cover over the muffl er.
Prise off the cable (A) from the ignition
module.
Remove the screws and lift off the ignition
module.
502 71 27-02
Remove the fl ywheel.
Remove the fl ywheel nut.
521 54 83-01
NOTE!
Place the piston stop so that it is trapped between the piston stop and the
combustion chamber. It must not stick out into the exhaust port.
Remove the fl ywheel from the crankshaft.
577 90 66-01
Dismantling
Dismantle the following parts to access
the ignition system:
The starter cover, the spark plug and the
protective cover over the muffl er.
Prise off the cable (A) from the ignition
module.
Remove the screws (B) and then remove
the ignition module (C).
Fit the piston stop no. 521 54 83-01 in
the spark plug hole and remove the nut
holding the fl ywheel.
Remove the fl ywheel from the crankshaft
using punch no. 577 90 66-01.
Leave a gap of approx. 2 mm between the
punch and the fl ywheel.
Gently knock the punch with a hammer
while lifting up the fl ywheel with your other
hand.
2
11