Table of Contents
Advertisement
Unpacking Instructions
•
Any damage should be immediately reported to the carrier.
•
The appliance should be unpacked immediately to check that it is intact and has suffered no
damage during transport.
•
Do not cut the cardboard with sharp tools to avoid damaging the underlying steel panels.
•
Lift the cardboard packaging up and off the appliance.
•
After having placed the appliance in its final position of installation, remove the wooden
base block.
•
Level the appliance by tightening or unscrewing or unscrewing the bottom part of the feet.
•
Connect it and leave it switched-on for a certain period (at lest some hours) before checking
its functioning. During the transport it is possible that some lubricating oil of the
compressor has come into the refrigeration circuit obstructing the capillary: consequentely
the appliance will work for some time not cooling till oil has returned into the compressor.
•
Remove the PVC protective film from the interior and exterior walls, avoiding the use of
metal tools.
8. INSTALLATION AND EXPLOITATION OF THE DEVICE
1. It is not allowed to switch the device on without efficient equipotential switch system!!! The
device is equipped with protective PE cord.
2. Before connecting mains to the device, check the voltage conformity between device and network
(data on rating plate).
3. Connecting the device to electrical network should be done in such a way that the plug is visible and
easily accessible for service.
It is inadmissible to use extensions and branch-joints!!!
4. The device should be powered from separate low-voltage circuit equipped with protective cord and
protected with fuse up to 10 A (shelves up to 16A).
Advertisement
Table of Contents
