Operation Flow - Azden 330 UPR User Manual

OPERATION FLOW

Connect the standard packed cable "stereo mini plug - dual XLR" . Connect the stereo mini
plug side to the receiver and the dual XLR side to video camera. The dual XLR side, CH1 is
white color marking and CH2 is black color marking. Make sure matching channel set between
the receiver and video camera. Camcorder supports Phantom power supply through
microphone jack.
Set the Phantom power supply feature to "off" position. Otherwise, it may damage the receiver.
The receiver and wireless microphone must use 1.5 m away or longer distance.
Otherwise, it may cause the interference.
Using two receiver at the same field, each receiver must have 3m or longer interval between
these two receivers.
Using the receiver with only one microphone, switch off the other microphone power.
330UPR shows channel information on the LCD panel. Currently set up "Channel number" or
"Frequency digit" can be switched via MODE switch (⑥)The details of channel figure refer page
8. The default figure from our factory is CH1: 001 / 794MHz and CH2: 121 / 800.00.
1.LCD panel information
a: Current display channel on the LCD
Selected channel number condition can be changed.
DISP1/2 can switch either channel.
b: Current set channel number
Channel number will be displayed and switched to the actual frequency value by pressing
MODE button.
Whenever the power on, previous channel number is displayed.
c: RF level indication with four bar
Four bar indication is strong and best audio receiving status.
d: Battery status
Vertically "three bar" is displayed when the power is at full condition.
Dual channel model with alkaline AA two batteries can operate for five hours.
When the last bottom bar start flashing, replace the batteries.
e: Audio transmission wireless frequency will be displayed through mode menu.
a
d
c
b
→
"MODE"
3
e