JVC KS-FX230 Service Manual page 8

KS-FX230
4. Set the catch to the holder arm ass'y as shown in
Fig.14.
5. While attaching the holder arm ass'y to the cassette
holder, insert the shaft of the holder arm ass'y into
the interlocking section k of the sub chassis ass'y as
shown in Fig.15.
6. Install the spring attached to the folder arm ass'y
shaft over the set arm ass'y as shown in Fig.16.
7. After the holder arm ass'y is installed, secure it with
the screw B. (see Fig.15)
Holder arm ass'y
8. After the installation, apply DC 6V to the lead wires
of the loading motor ass'y to locate the load gear
ass'y as shown in Fig.17.
9. Install the load arm ass'y.
10. Install the head relay PCB.
NOTE : Install it so that the slide switch lever of the
head relay PCB is set in the PCB stay hook
of the sub chassis ass'y. (see Fig.18)
11. Solder the loading motor and head lead wires to the
head relay PCB, respectively. (see Fig.19)
Head PCB
1-8
Spring
Set arm ass'y
Fig. 16
Fig.19
Holder arm ass'y
Catch
Holder arm ass'y
Cassette holder
Loading motor
Apply DC 6V
Fig.14
B
k
Refer to Fig.16
Fig.15
Fig. 17
Slide switch
PCB stay
Fig.18