JVC KS-F185 Service Manual page 6

3.1.4 Removing the heat sink
(See Fig.4)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) Remove the screw B and two screws C attaching the heat
sink on the left side of the body, and remove the heat sink.
3.1.5 Removing the rear panel
(See Fig.5)
• Prior to performing the following procedure, remove the front
panel assembly and bottom cover.
(1) Remove the two screws D , screw E and three screws F at-
taching the rear panel on the back of the body.
3.1.6 Removing the main board
(See Fig.6)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover, front chassis assembly, heat
sink and rear panel.
(1) Remove the two screws G attaching the main board on the
top chassis.
(2) Disconnect the two connectors
main board from the cassette mechanism assembly.
1-6 (No.MA094B)
(CN901 and CN721) on the
C B
Heat sink
Fig.4
D F
Rear panel
E
Fig.5
CN721 Main board
G
CN901
Fig.6
C
F
D
G