Installing The Recorder - Fluke 1750 Getting Started Manual

•
End of recording session
You can re-verify if desired, correctness of live data and then download data,
power off the Recorder, and pack up for transport.

Installing the Recorder

1. Position the Recorder within 2 m (6 ft) of the monitoring location.
2. The Recorder can be set on the floor or a table, or attached and secured to
a pole or other mounting surface. The Recorder can be oriented vertically
or horizontally.
3. Connect the Recorder to a 100 to 240 V ac power source, 50 or 60 Hz.
4. Plug the power cord into a properly-grounded wall outlet.
To avoid damage to the Recorder:
• Ground the chassis as appropriate according to your
power connection before you do anything else.
• Connect the power cord to the Recorder using the
appropriate supplied adapter.
• Connect the power cord to a properly grounded wall
outlet.
• Be sure to plug the power cord into the Recorder panel
BEFORE connecting it to an outlet.
After a minute, or two, all LEDs should flash ON, then OFF, and then each
should turn ON and OFF in sequence. The LEDs will then remain on if you
make secure test lead connections and there is sufficient voltage and current.
5. Turn on the PDA and tap the Power View icon
If a Recorder is within range and is not password protected, it should
appear in the drop down menu just below the main title bar on the PDA.
You may need to select Browse for recorder when first connecting.
Select the recorder you want to browse to with the PDA stylus. Upon
selection, the Home screen for live data appears.
Installing the Power Recorder at a Facility
Caution
Power Recorder
to launch Power View.
13