Switch Management; Management Options; Using Web-Based Management; Supported Web Browsers - D-Link DGS-1210/ME Series Hardware Installation Manual

DGS-1210/ME series Metro Ethernet Switch Hardware Installation Guide
3

Switch Management

This chapter introduces the management interface of D-Link DGS-1210/ME Metro Ethernet Switch.


Management Options



Using Web-based Management


Connecting to the Console Port
Management Options
The D-Link Metro Ethernet Switch can be managed through any port on the device by using the Web-based
Management or command line interface.
Each switch must be assigned its own IP Address, which is used for communication with the Web-Based
Management or a SNMP network manager. The PC should have an IP address in the same range as the
switch. Each switch can allow up to four users to access the Web-Based Management concurrently.
Please refer to the following installation instructions for the Web-based Management.
Using Web-based Management
After a successful physical installation, you can configure the Switch, monitor the network status, and display
statistics using a web browser.

Supported Web Browsers

The embedded Web-based Management currently supports the following web browsers:
Microsoft Internet Explorer 10/11
Microsoft Edge 25
Chrome 51
Safari 5.1.7

Connecting to the Switch

You will need the following equipment to begin the web configuration of your device:
1. A PC with a RJ-45 Ethernet connection
2. A standard Ethernet cable
Connect the Ethernet cable to any of the ports on the front panel of the switch and to the Ethernet port on the
PC.
Figure 3.1 – Connected Ethernet cable
18