Technics SC-C70 Basic Operating Instructions Manual page 15

■
Using the WPS PIN code
"WPS PIN"
If your wireless router supports WPS, you can
set up a connection by entering the WPS PIN
code.
• For details on how to enter the PIN code, refer
to the operating instructions of the wireless
router.
1 Press [ ], [ ] on the remote control
to select "WPS PIN" and then press
[OK].
• The PIN code is displayed. Complete step 2
within 2 minutes.
2 Enter the PIN code into the wireless
router from PC, etc.
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 13).
3 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.
Note
• Depending on a router, other connected
devices may temporarily lose their connection.
• For details, refer to the operating instructions
of the wireless router.
■
Using "Technics Music App"
"Setup from Browser"
If you install the dedicated app "Technics
Music App" (free of charge) on your Android
device, you can set up a connection using the
application.
• If you're using an Android device, download
the app at Google Play™.
• Check the password for your home wireless
network.
• Make sure your Android device is connected to
your home wireless network beforehand.
• This unit uses the 2.4 GHz frequency band
only. Check your Android device is connected
using 2.4 GHz band.
1 Press [ ], [ ] on the remote control
to select "Setup from Browser" and
then press [OK].
• "Setting" is displayed.
2 Start "Technics Music App" on the
Android device.
3 Select " " and go to Wi-Fi settings.
4 Enter the password for your home
wireless network.
5 Select "Next" to apply the settings.
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 13).
• Depending on the device, the connection
complete screen may not be displayed.
6 Make sure to connect your Android
device back to your home wireless
network.
7 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.
15