Table of Contents
Advertisement
3.2.2 Removing the traverse mechanism assembly (See Figure 6)
(1) Reverse the loading mechanism assembly.
(2) A card wire is removed from a wire bracket.
(3) Remove the four screws B attaching the traverse mecha-
nism assembly. Remove the traverse mechanism assem-
bly upward.
3.2.3 Removing the elevator (See Figure 8 and Figure 9)
• Prior to the following procedure, remove the traverse mecha-
nism assembly.
(1) Remove the two arms of the elevator from the two parts f
by moving the arms in a direction of the arrow.
(2) Pull out the elevator in a rear direction.
Attaching the elevator:
Engage the two holes g to the two shafts on the front part of
the elevator. And then, attach the elevator.
Loading mechanism assembly
B
B
Traverse mechanism assembly
Fig.7
Part f
Fig.8
Elevator
Shaft
Shaft
Fig.9
B
wire
bracket
B
Elevator
Part f
g
Slide cam
g
(No.YD095)1-13
Advertisement
Table of Contents
