JVC UX-P550 Service Manual page 9

3.1.3 Removing the top cover assembly
(See Figs.9 to 11)
• Prior to performing the following procedures, remove the side
panels L/R and front panel assembly.
(1) From the back side of the main body, remove the screw D
attaching the top cover assembly to the rear panel. (See
Fig.9.)
(2) From the right side of the main body, disconnect the card
wires from the connectors (CN701, CN702) on the main
board. (See Fig.10.)
(3) From the left side of the main body, disconnect the card
wire from connector CN601
board. (See Fig.11.)
Reference:
When reassembling, pass the card wire through the sec-
tion e of the microphone amplifier board before connect-
ing the card wire to the connector CN601. (See Fig.11.)
(4) Take out the top cover assembly from the main body.
Top cover assembly
Rear panel
on the microphone amplifier
D
Fig.9
Top cover assembly
Card wires
CN702
Main board
Fig.10
Microphone amplifier board
CN601
e
Card wire
Fig.11
CN701
(No.MB286)1-9