Control By The Serial Terminal - Panasonic TH-75BQE1W Operating Instructions Manual

Control by the serial terminal

1 Control by the serial terminal
From the [Setup] menu, set [Control Setting] to [SERIAL IN]. (see page 44)
RS-232C cable:
Connect a serial cross cable (reverse) to the SERIAL IN terminal (male).
Select the RS-232C cable for communication used for connecting SERIAL IN terminal and computer according to
the computer you are using.
Use RxD, TxD, and GND cables for directly connecting with serial terminal.
You can control the display remotely by using this communication interface.
2
Communication conditions
Signal level: RS-232C compliant
Synchronization method: Asynchronous
Baud rate: 9600 bps
Parity: None
Character length: 8 bits
Snap bit: 1 bit
Flow control: None
Basic format
Transmission from the computer will start with STX
followed by commands and parameters. In the
end, ETX will be sent. Add parameters as required
according to control details.
3 List of commands
Command Parameter
PON None
POF None
***
AVL
0
AMT
1
None
HM1
HM2
IMS
DV1
PC1
UD1
0
VMT
1
Control details
Power ON
Power OFF
Volume 000 ‒ 100
Mute Off
Mute On
Input select (toggle)
HDMI 1 input (HDMI1)
HDMI 2 input (HDMI2)
DVI-D IN input (DVI-D)
PC IN input (PC)
USB input (USB)
Video mute (including
OSD) Off
Video mute (including
OSD) On
STX C1 C2 C3 :
Start Colon
Command 3 characters
(3 Byte)
Note
●
When sending multiple commands, make sure to send
the next command only after receiving response from
the device. Colon (:) is not required when sending a
command that doesn't require any parameter.
●
Sending an incorrect command will result in the
transmission of a command called "ER401" from the
device to the computer.
● During the power supply "Standby" state (power
supply "Off" in the remote control), working of
commands other than the "PON" command is not
guaranteed.
●
Please contact your dealer for the details of
commands. Or, refer to the following support website.
https://panasonic.net/cns/prodisplays/
P1 P2 P3 P4 P5 ETX
Parameter
English
End
37