1-4. Opening and closing the windows and moon roof
When the power window does not close normally
■
If the jam protection function is operating abnormally and a window cannot
be closed, perform the following operations using the power window switch
on the relevant door.
After stopping the vehicle, the window can be closed by holding the
●
power window switch in the one-touch closing position while the engine
switch is turned to the "ON" position (vehicles without a smart key sys-
tem) or the "ENGINE START STOP" switch is turned to IGNITION ON
mode (vehicles with a smart key system).
If the window still cannot be closed even by carrying out the operation
●
explained above, initialize the function by performing the following proce-
dure.
STEP
1
Hold the power window switch in the one-touch closing position.
Continue holding the switch for a further 6 seconds after the win-
dow has closed.
STEP
2
Hold the power window switch in the one-touch opening position.
Continue holding the switch for a further 2 seconds after the win-
dow has opened completely.
STEP
3
Hold the power window switch in the one-touch closing position
once again. Continue holding the switch for a further 2 seconds
after the window has closed.
If you release the switch while the window is moving, start again from the
beginning. If the window continues to close but then re-open slightly even
after performing the above procedure correctly, have the vehicle inspected
by your Toyota dealer.
146
SIENNA_OM_OM45472U_(U)