Pre Cutting Test; Stopping The Engine; Chain Lubrication Test; Checking Chain Tension - Shindaiwa 269T Instruction Manual

Release the chain brake
CAUTION
1. After starting the engine, squeeze throttle
trigger slightly to release throttle latch and pull
front hand guard towards the operator
immediately. (Chain brake RELEASED
position)
2. Do not increase engine speed while chain
brake is engaged.
3. Use the chain brake in an emergency.
Do not use it unless absolutely necessary.
CAUTION
When throttle latch is used, saw chain will go into
motion as soon as the engine starts. Never use
throttle latch for cutting.
Use it only when starting the engine.

STOPPING THE ENGINE

• Release throttle trigger and allow engine to idle.
• Place ignition switch in STOP position.
NOTE
When engine does not stop, turn choke control knob
counterclockwise to stop engine.
Check and repair ignition switch before starting the
engine again.

CHECKING CHAIN TENSION

• Chain tension should be checked frequently during
work and corrected if necessary.
• Tension the chain as tight as possible, but so it can
still be pulled easily along the bar by hand.
WARNING
MAKE SURE THAT THE ENGINE IS SHUT OFF
WHEN CHECKING CHAIN TENSION.
Ignition switch
Throttle trigger
lockout
Throttle trigger
DANGER
RUNNING
• After engine starts, allow it to idle for a few
minutes.
• Squeeze throttle trigger gradually to increase
engine revolution.
• The chain starts moving when the engine reaches
4,500 r/min approximately.
• Ensure proper acceleration and lubrication of saw
chain and guide bar.
• Do not run the engine at high speed unnecessarily.
• Be sure that saw chain stops moving when throttle
trigger is released.

PRE CUTTING TEST

• Familiarize yourself with your chain saw before you
start actual cutting.
• For this purpose it may be wise to practice by
cutting some small logs or limbs several times.
• Do not allow anybody and animal into the work area.
Multiple operators - Keep a safe distance between
two or more operators when working together
simultaneously.

CHAIN LUBRICATION TEST

Hold the chain just above a dry surface and open the
throttle to half speed for 30 seconds.
A thin line of "thrown" oil should be seen on the dry
surface.
14
Throttle trigger lockout
Throttle trigger