Vent Lines; Fuel Filter; Carburetor Draining - Polaris A09BG50AA User Manual

MAINTENANCE

VENT LINES

1. Check fuel tank, oil tank, carburetor, battery and
transmission vent lines for signs of wear,
deterioration, damage or leakage. Replace every
two years.
2. Be sure vent lines are routed properly and
secured with cable ties. CAUTION: Make sure
lines are not kinked or pinched.

FUEL FILTER

The fuel filter should be replaced in accordance with
the Periodic Maintenance Chart.
1. Shut off fuel supply at fuel valve.
2. Remove line clamps at both ends of the filter.
3. Remove fuel lines from filter.
4. Install new filter and clamps onto fuel lines with
arrow pointed in direction of fuel flow.
Fuel Filter Located Close To Carburetor
Arrow Indicates Direction of Flow
5. Install clamps on fuel line.
6. Turn fuel valve ON.
7. Start engine and inspect for leaks.

CARBURETOR DRAINING

The carburetor float bowl should be drained
periodically to remove moisture or sediment from the
bowl, or before extended periods of storage.
Drain tube
attached
here
Drain Screw
NOTE: The bowl drain screw is located on the bottom
left side of the float bowl.
2.18
1. Turn fuel valve to the off position.
2. Place a clean container beneath the bowl drain
To Carburetor
3. Turn drain screw out two turns and allow fuel in
4. Inspect the drained fuel for water or sediment.
5. Tighten drain screw.
6. Turn fuel valve to "ON".
7. Start machine and check for leaks.
NOTE:
reattached as this will effect engine performance.
spigot or bowl drain hose.
Fuel Valve Location
RES
OFF
ON
Fuel Valve
the float bowl and fuel line to drain completely.
If there is a tube attached, it must be