Verifying And Diagnosing Transceiver Modules; Verifying Transceiver Modules - HP 5130 EI series Configuration Manual

Step
2. Configure the temperature
alarm thresholds.
Table 13 Default temperature alarm thresholds
Device model
HP
5130-24G-4SFP+
EI Switch(JG932A)
HP
5130-24G-SFP-4SF
P+ EI
Switch(JG933A)
HP
5130-24G-PoE+-4
SFP+ (370W) EI
Switch(JG936A)
HP
5130-48G-4SFP+
EI Switch(JG934A)
HP
5130-48G-PoE+-4
SFP+ (370W) EI
Switch(JG937A)

Verifying and diagnosing transceiver modules

Verifying transceiver modules

You can use one of the following methods to verify the genuineness of a transceiver module:
Display the key parameters of a transceiver module, including its transceiver type, connector type,
•
central wavelength of the transmit laser, transfer distance, and vendor name.
Command
temperature-limit slot slot-number
hotspot sensor-number lowlimit
warninglimit [ alarmlimit ]
Temperature Low-temperature
sensors threshold
Hotspot 1 0°C (32°F)
Hotspot 2 0°C (32°F)
Hotspot 1
through 0°C (32°F)
Hotspot 3
Hotspot 4 0°C (32°F)
Hotspot 1 0°C (32°F)
Hotspot 2 0°C (32°F)
Hotspot 3 –20°C (–4°F)
Hotspot 4 0°C (32°F)
Hotspot 1
through 0°C (32°F)
Hotspot 4
Hotspot 1
0°C (32°F)
Hotspot 2
Hotspot 3
0°C (32°F)
Hotspot 4
Hotspot 5 –20°C (–4°F)
Hotspot 6 0°C (32°F)
High-temperature
warning threshold
103°C (217.4°F)
100°C (212°F)
80°C (176°F)
95°C (203°F)
92°C (197.6°F)
98°C (208.4°F)
63°C (145.4°F)
110°C (230°F)
98°C (208.4°F)
90°C (194°F)
98°C (208.4°F)
67°C (152.6°F)
110°C (230°F)
125
Remarks
The default settings are shown
in Table 13.
The high-temperature alarming
threshold must be higher than the
high-temperature warning
threshold. The high-temperature
warning threshold must be higher
than the low temperature
threshold.
High-temperature
alarming threshold
108°C (226.4°F)
105°C (221°F)
85°C (185°F)
100°C (212°F)
102°C (215.6°F)
108°C (226.4°F)
70°C (158°F)
130°C(266°F)
108°C (226.4°F)
100°C (212°F)
108°C (226.4°F)
72°C (161.6°F)
130°C(266°F)