Table of Contents
Advertisement
CCZ092comb.QX33
4/5/99 6:06 PM
30 One-Touch Recording
The One-Touch Recording (OTR) function allows you to program
an immediate timed recording from 30 minutes to eight hours
long without setting the timer.
Before you begin, make sure:
Channels are set up.
There is a tape in the TV/VCR. The record tab must be intact.
1
Use the CHANNEL
to select the channel you want to record.
2
Press the SPEED button until the desired recording speed
(SP, LP, or SLP) appears on-screen. Details are on page 29.
3
Press the REC(ord)/OTR button repeatedly until the
desired recording length appears in the upper right corner of the
screen. Recording will begin immediately. The REC(ord) light will
appear.
OTR
LENGTH 0:30
CH12
LENGTH : PRESS OTR
CANCEL : PRESS CLEAR
4
To stop an OTR before recording is finished, press the
STOP/EJECT button on the TV/VCR.
Or, press the REC(ord)/OTR button, then press the
CLEAR button, then press the STOP/
remote control.
Page 30
/
buttons or the Number buttons
button on the
4
Press the STOP/EJECT but-
ton on the TV/VCR to stop
the OTR.
2
3
1
5
6
4
o
8
9
7
p
0
+100
o
2
p
o
PLAY
REW
F.FWD
STOP
3
p
o
p
Helpful Hints
• To check the time remaining for an
OTR after the OTR has been set,
press the STATUS/EXIT button.
• To change the recording length
while an OTR is in progress, press
the REC(ord)/OTR button until the
desired recording length appears
on-screen.
• You can not pause an OTR.
• To cancel an OTR but continue
recording, press the REC(ord)/OTR
button, then press the CLEAR but-
ton.
• You cannot record if RECORD
DEFEAT is set to ON. Details are
on page 36.
• You can change the tape speed
with the SPEED button while a
recording is in progress, but some
distortion may appear on the tape.
• If the end of the tape is reached
during an OTR, recording will stop.
The TV/VCR will eject the tape and
shut itself off. The REC(ord) light
may flash.
1
Advertisement
Table of Contents
