Canceling Ext Option; Self-Check Mode; Procedure To Enter The Self-Check Mode - Panasonic PT-F100NTU Service Manual

Hide thumbs Also See for PT-F100NTU:

Quick manual (1 page)

Manual (78 pages)

Operating instructions manual (66 pages)

Table Of Contents

Table of Contents

according to connected equipment. In this case, set HPLL to OFF.

· EMULATE

Switching the operation of RS-232C command to communicate with models other than F100 series.

− − − − DEFAULT: F100/F100NT standard, D3500

− − − − TYPE1: L730/L780/L735/LB/LC series

− − − − TYPE2: L785

− − − − OTHER: Models other than the above-mentioned (Consult your dealer or Authorized Service Center for details.)

· AUDIO IN STANDBY

Setting the audio output when STANDBY

− − − − OFF: Does not output it.

− − − − ON: Outputs it.

Note:

− − − − When setting it to "ON", audio source of the input channel when the power supply is turned off (switched to STANDBY)

is outputted. Do with the remote control unit, control panel or RS-232C communication when you switch the channel.

The audio volume can be adjusted by the remote control unit or RS-232C communication.

· OVER SCAN

Setting the rate of over scanning

− − − − 1: Approx. 6%

− − − − 2: Approx. 4%

Note:

− − − − Normally, set it to "1".

· MENU LOCK

Switching ON/OFF "MENU LOCK" function

− − − − OFF: Accessible to MENU

− − − − ON: The access to MENU is restricted (The password is required).

− − − − When MENU LOCK is set to "ON", the password input screen is displayed when it accesses the menu, and the

adjustment in the menu item is locked.

· MENU LOCK PASSW ORD

Setting the password into MENU LOCK

− − − − The default password is "AAAA".

When you want to reset the password into the default password, do the following operation.

1. Press on the remote control unit the AUTO SETUP button, or on the main unit the INPUT SELECT button and the

button at the same time for 2 seconds or more.

2. Press

button for 2 seconds or more.

· ARF ROLL

Rolling the ARF (Auto Rolling Filter) compulsorily.

· SELF CHECK

To enter the self-check mode

· TEST PATTERN

To display test patterns

· FLICKER ADJUST

To enter the flicker adjustment mode

2.3.