Table of Contents
Advertisement
Remove the two screws on the
cover plate to remove the piece that
fits over the air control rod. Then
replace the piece when the cover
plate is in place.
Attach the included
gasket to all four top
edges of the air boot.
Attach gasket to the bottom
edge of the air boot.
The cover plate has a clip which attaches
it underneath the air control.
Bottom of Stove
Use the included screws to attach
the two telescoping portions of air
boot together. The included drill bit
5-1/8"
should be used to drill the hole.
Make sure the air boot is expanded
8-7/8"
to the correct size before drilling.
9/64" Drill Bit
Floor (and hearth)
Air Control Rod
Use a
screwdriver to
pry out the
knock-out.
Attach the air boot with
the two screws included
with the kit.
1/4" Nutdriver
5/16" Nutdriver
The hole in the floor (and hearth)
must be a minimum 16 square
inches. It should be 1/2" smaller
than the footprint of the air boot in
each dimension to allow for the
gasket to seal.
Hide quick links:
Advertisement
Table of Contents
