Bissell 2087 series Quick Start And User Manual page 14

Clean Inner Cyclone Separator
1
Twist tank cover to the
unlock position then pull
up on handle to access
bulk separator.
Maintain Pet TurboEraser® Tool
1
3
To reassemble, align two clips on each end
of paddle wheel with belt on and pop back
into place. Place brush roll with belt back in.
Faceplate will not close properly if all parts
are not aligned correctly.
14
www.BISSELL.com
2
Pull up to remove the
bulk separator from dirt
container.
Twist gray collar
counter-clockwise, until
slot appears, and then
separate faceplate.
3
Tap separator against inside
of trash bin and rinse under
warm water, if necessary. Be
sure to let it completely dry
before placing back in dirt
container. When replacing,
be sure that separator
aligns with the upper tank
to ensure fit.
Paddle Wheel
2
Belt
Roller
Remove brush roll, belt, and pad-
dle wheel. Inspect for damages and
replace if necessary.
4
To put faceplate back on, align the tabs
in the top of the cover and place it down
to "click" into place.